SX Core (Mariko V2) only boots into OFW

[Kilik]

Hi! All went good, I got the green LED and the SD Card logo. I am using SX OS V3.0.4 on a FAT32 SD Card (Guiformat FAT32) I can enter the boot menu, but when I select "boot costum FW" it always boots into the original FW. I tried different SD Cards (512 and 128 GB) and exFat, I already got the full SC OS license. I'll also check the SC Card Reader connection (again). What else can I do? Would it still boot into the menu if the solder points were no good? Thanks for your support

 

[Grimlock97]

Hey, go to album menu and see if you get the tx menu. the cfw does not differ from ofw when it comes to the UI. Just go to album when you boot to cfw and you will see tx menu

 

[Kill-Bill6]

Switch not booting after installing sx core

Hey my Switch not booting after installing sx core I tried everything but nothing I even unsorder back the chip and put back the emmc back at its original place but still doesn't comes on what to do... I need you'll help please

team-xecuter.com

I need help

Hey, go to album menu and see if you get the tx menu. the cfw does not differ from ofw when it comes to the UI. Just go to album when you boot to cfw and you will see tx menu

I need help

 

[Kilik]

Hey, go to album menu and see if you get the tx menu. the cfw does not differ from ofw when it comes to the UI. Just go to album when you boot to cfw and you will see tx menu

Thanks so much! It was working the whole time.. oh man. But it's odd, first I could boot info CFW with exFAT, now only FAT32 is working. I could get the exFat Driver via official update when booting into OFW with the card inserted. As the Switch is already on 10.1.0 I would not risk an unwanted update or get banned right?
Also why do I even need emuNAND? Here are some (horrible) pics of the soldering:

I checked it, it's connecting fine and in reality it does not look that ugly. But tough installation I have to admit.