Hello,
I installed core successfully, had the green light and grumpy logo, downloaded latest boot.dat from website and booted to sx home screen then tried making a nand backup, while it was busy with that the screen went blank, pressed the power button to switch it off and when i tried restarting it didn't want to go on.
Checked and re-soldered as per the suggestions on the TX Support chat but still no power.
Things i've tried and Notes:
I've tried putting in the original nand and booting but also no power.
Left it plugged in overnight.
Im not skilled but I've tried looking at the board and i can't pick up anything obvious that i broke.
The switch was plugged into power when i was doing the nand backup.
On opening it up again after the failed nand backup attempt, i noticed the usb port was a bit crushed.
Im going to try and get a multimeter today but i don't really know how to use it to test.
Any assistance would be appreciated, thanks so much!
SX Core Install
Zoomed out view
I installed core successfully, had the green light and grumpy logo, downloaded latest boot.dat from website and booted to sx home screen then tried making a nand backup, while it was busy with that the screen went blank, pressed the power button to switch it off and when i tried restarting it didn't want to go on.
Checked and re-soldered as per the suggestions on the TX Support chat but still no power.
Things i've tried and Notes:
I've tried putting in the original nand and booting but also no power.
Left it plugged in overnight.
Im not skilled but I've tried looking at the board and i can't pick up anything obvious that i broke.
The switch was plugged into power when i was doing the nand backup.
On opening it up again after the failed nand backup attempt, i noticed the usb port was a bit crushed.
Im going to try and get a multimeter today but i don't really know how to use it to test.
Any assistance would be appreciated, thanks so much!
SX Core Install
Zoomed out view