SX Lite 1.3 - SX OS 3.0.3 - FW 10.0.4 - emuNAND problem

[benjokazooy]

I prefear open a specific thread.
I've installed the SX Lite over Nintendo Switch Lite.
The Switch have the System 10.0.4.
The Sx Lite is update to fw1.3.
The Sx OS is the 3.0.3 beta.

The SX Lite boot very well the CFW in sysnand but if i create a emuNAND with SX Menu tool, it not boot. only SX Splash screen then black screen.
I tried 2 different microSD card that i've already used with emu n the past with ReiNX and Atmosphere.
The switch response very well, the SX OS menu is ok and sys CFW boot properly.
Only emuNAND have problem to boot.

Is it a known issue?
Any solution about that?

 

[Grimlock97]

Contact TX Support via live chat

 

[hatzumi187]

i updated switch before intsalled SX Core to 10.4
SX Core installed an blinking grenn (all ok)
booted to SX OS 3.03
created nand backup, than Emunand (treid on two diffrent scdards)

i could not boot to cfw only to original firmware
maybe i have the same problem with emunand?!

if i boot to original firmware a system message pop up to update the switch to read sdxc cards
can i go online on this point or will I be banned

how can i fix it?

thx for help
@benjokazooy

i think we have to install the exFAT driver first in sysnand and then make a emuNand boot.

First i try now with fat32 formatted sd card to see if this is the problem (Dumping raw nand....78%)

-----
ok
now with fat32 formated sdcard emunand boot

thx to izy and Alchemy.Gaming for help

 

[jinfeng55]

do you use samsung evo plus 512GB ?

I have same problem on evo plus 512GB.
Sandisk 512GB or Evo plus 256GB is no problem.

change SD Card..

This issue only occurs on certain switch v2 and lite.

 

[Chxtreme]

Hi, i am on switch lite sxos 3.03, firmware 10.4 was having same issue that couldn't boot into cfw until i create emunand but disable (due to not yet activate). After boot into 'cfw', when i click on Album, it just normal album (seems like not cfw), cant go in sxmenu to activate my license. Then i proceed with online license.dat create and put to root of sdcard (fat32), but when boot it just boot loop between Nintendo logo and joycon logo, if i unplug sdcard in middle of boot loop, it just boot to normal firmware. Anyone can help?

 

[Chxtreme]

Update: my issue resolved after replaced with new sxlite modchip. It appear problem at modchip itself.