Hey guys I have a SX Pro dongle and the rcm jig. I updated my switch to 6.2 and I uploaded SX OS 2.5 beta onto my sd card and deleted my other boot file. My switch will not go into the rcm mode with the dongle and jig connected to my switch. Wont show anything when I hold now the power button and vol+. The switch will turn on normally just not rcm mode. Can someone help me please ? I tried to find some information on it and im not sure if I need to inject a new payload using tegra GUI ? I really have no idea since using SX Pro is quite easy to set up and use. I appreciate your guys help, Thank you !
SX Pro 6.2 problem, wont go into rcm mode... PLEASE HELP !!
- Thread starter Chopr2x
- Start date
Check your serial number here: https://team-xecuter.com/forums/thr...-Switch-is-currently-unhackable-(August-2018)
Hello,
I have the same problem on another switch. I already done the operation on 3 switch without problem.
The serial is XAJ7005 so normaly it' ok.. At the beginning, the led is green without the jig. With the jig, impossible to boot, just blue led during 1 second.
Somebody know the problem ?
Thanks you
PS : sorry for my english.. i'm french
I have the same problem on another switch. I already done the operation on 3 switch without problem.
The serial is XAJ7005 so normaly it' ok.. At the beginning, the led is green without the jig. With the jig, impossible to boot, just blue led during 1 second.
Somebody know the problem ?
Thanks you
PS : sorry for my english.. i'm french
xaj7005 is a patched console. the sx pro won't work.Hello,
I have the same problem on another switch. I already done the operation on 3 switch without problem.
The serial is XAJ7005 so normaly it' ok.. At the beginning, the led is green without the jig. With the jig, impossible to boot, just blue led during 1 second.
Somebody know the problem ?
Thanks you
PS : sorry for my english.. i'm french
It's strange because i already have a XAJ4006 and it's work .. ?!
Is the an alternativ with reinx or atmosphere ?
Is the an alternativ with reinx or atmosphere ?
there is a post right above you with the serial numbers, you don't check -_-.
its been patched means its UNHACKABLE, reinx atmosphere and SXOS all use the same exploit. If won't work for one, won't for for any.
Serials beginning with XAJ7:
XAJ700400 (and lower) - Not Patched
XAJ700410 (and above) - Possibly patched
XAJ700500 (and above) - Patched
i checked on this too : https://akdm.github.io/ssnc/checker
i have a switch with XAJ4006, it's write patched but it's works
i have a switch with XAJ4006, it's write patched but it's works
Recently my Switch started to connect directly to the Nintendo logo, it only goes into RCM when I connect it with the JoyCon right connected, I disconnect and later use the Jig normally. It may be coincidence that I had not noticed before.
Check that you have autoRCM enabled or disabled. If you have autoRCM on and you don't hold the Vol + it will just try to boot to your CFW.
It was in version 2.4.1, I returned to version 2.4 and the problem stopped ... later I updated to 2.5 and the problem no longer occurred, I do not know if it is related to enter rcm mode with the cfw version, but it did not come back to happen, I do not have AutoRcm installed, but I'm thinking about the possibility ... I use Sx Pro. Tanks