SXOS 2.9.2 NSW FW 9.1.0 - Custom FW Black scree

[Vyker]

Hello,

I was on an older SX OS and on 4.1 FW.

I wanted to play a new game that needed a newer FW.

So I downloaded choi, fw 9.1.0, and SXOS 2.9.2.

I updated the firmware, and when it rebooted, it never came back on. I suspected it was because choi enabled AutoRCM. So I used tegra to force hetake payload and in that, I turned off AutoRCM. (i had to do this as the pro dongle wouldnt boot up)

I then put my jig and pro dongle back in, and booted up. Bootloader works fine, but once I press "custom FW", the screen goes blank.

I checked with bricii and i'm on 12 burns. (which lines up with 9.1.0) - the device has never been online.

The device works fine when I just power it on normally. Controllers have been updated too.

Please can someone help me troubleshoot where to go next to get it working again?

Thanks

 

[Hackerjac]

Hello,

I was on an older SX OS and on 4.1 FW.

I wanted to play a new game that needed a newer FW.

So I downloaded choi, fw 9.1.0, and SXOS 2.9.2.

I updated the firmware, and when it rebooted, it never came back on. I suspected it was because choi enabled AutoRCM. So I used tegra to force hetake payload and in that, I turned off AutoRCM. (i had to do this as the pro dongle wouldnt boot up)

I then put my jig and pro dongle back in, and booted up. Bootloader works fine, but once I press "custom FW", the screen goes blank.

I checked with bricii and i'm on 12 burns. (which lines up with 9.1.0) - the device has never been online.

The device works fine when I just power it on normally. Controllers have been updated too.

Please can someone help me troubleshoot where to go next to get it working again?

Thanks

Update SXOS to 2.9.3 and try again

 

[Vyker]

That worked.... how did you know? I'm amazed. Thank you.

Is 2.9.2 not working with 9.1?

Thank you!!!!

 

[Hackerjac]

That worked.... how did you know? I'm amazed. Thank you.

Is 2.9.2 not working with 9.1?

Thank you!!!!

Yes 2.9.2 is for 9.0.1 and 2.9.3 is needed for 9.1