RGH T-X UPCB Fresh Install

[Console Clinic]

Possibly fw issue? LTU Unlocked T-X PCB flashed with LTU 1.0, in console, fresh installation.

I'll get around 15 mins. normal functioning and then no response at all, however i can get back to dash via guide button but that's it. If we try to switch on straight away after switching off, same symptoms, leave it for 5, 10 mins. and all is good again.

Green dot will flash, indicating no drive attached perhaps??

Searched many posts, no luck.

Incidentally i recall the first time i installed the drive, (originally 1532), it was completely unresponsive, i un-plugged and plugged back up and all was good, i just assumed connector wasn't seated correctly, even though i'm a fussy tart and always make sure my connections are cool.

Any suggestions much appreciated before i dis-mantle.

 

[Console Clinic]

Anyone? :frown:

 

[Utmad]

Does it do the same with original disks

 

[Console Clinic]

Good point, didn't dawn on me to try, give it a bash now.

 

[Console Clinic]

Exactly the same with originals, the only reason i didn't strip it when customer brought it back yesterday was because he said he'd come by next week for it. I've never experienced this issue with 4S unlocked pcb'.

 

[Utmad]

I would try re-flashing the firmware.

 

[Console Clinic]

Shame i'm a pessimist sometimes, hope it's that simple. Give it a whirl and get back,......