TDO MISMATCH with Demon + CR3 Pro

[[email protected]]

Hi,
I have Trinity with stock nand 13064, CR3 Pro + Demon + QSB installed. Demon's firmware is version 1.4.
After reading NAND, by flashing to coolrunner i've got error TDO MISMATCH.
I've checked all connection and seems everything OK.
1. Can you please help me what to do next?
2. By pressing F2 in J-Runner demon doesn't read mb type. Is it fault? JR2 reads it without problem.
Thank you



J-Runner log: View attachment tempLog.txt

 

[jsinger47]

DO NOT ATTEMPT TO FLASH YOUR CR3 PRO. YOU WILL DAMAGE IT.

 

[Martin C]

I don't think you were clear enough...

From
CR3 PRO v1.0S FULL POST - Installation & Tuning Guide *UPDATED FEB 16 12:39AM GMT*

Warning

DO NOT - I REPEAT - DO NOT ATTEMPT TO WRITE ANY TIMING FILE TO YOUR CR3-PRO. They are pre-programmed. Writing any other timing file to the CR3-Pro without instruction from T-X may result in permanently damaging it

 

[jery911]

lol and another one bites the dust :facepalm:

 

[jsinger47]

lol and another one bites the dust :facepalm:

no, it didn't

 

[[email protected]]

Thanx, now its clear. CR3 is ok. What about mb type read?

 

[Martin C]

2. By pressing F2 in J-Runner demon doesn't read mb type. Is it fault? JR2 reads it without problem.

Just carry on with the RGH process. If you can read/write to the DemoN and read the stock NAND then you are ok.