duffman452
Full Member
- Apr 3, 2011
- 50
- 0
Anyone know if its nessacary to add the resistor in a series or can you just use 1 10 omh resistor?
i don't believe that the length of the E and F wires are very influential on boot timeswhat will be the ideal length of the green & brown wire ?? same as red wire ??
Sorry but you are wrong."You were already given a RGH solution for Xenon's. If it's useless to you make your own hack - I'm getting a little irritated at your complaining."
i guess i wouldn't feel so jilted if i hadn't been told for the last month that rgh 2.0 would work on my xenon with 14719 dash!:rolleyes2:
b
The correct wire lengths are supplied with the cool runnerwhat will be the ideal length of the green & brown wire ?? same as red wire ??
What I was saying is that if you have a spare Samsung drive that isn't flashed with ixtreme firmware, then you can update your console with no problem. If you are on 14717 and want to update to 14719, then put the Samsung drive in, start it up, then update. It should update with no errors. I have done it a few times, tested and working. Again, I don't remember where I saw this at, but I would like to give them credit, so if anyone has heard it and know where it came from, please tell me!Most of the posts regarding the missing keys stated they had already updated to the latest dash. So flashing to 13599 would be out of the question.
I used slim's wire and to add 10 ohm resistor I have cut the blue wire 3cm because resistor length was 3cm. its working. But boot time is always vary from 3 to 5 glitch. ThanksThe correct wire lengths are supplied with the cool runner
this is only for phat since u have a trinity just use jrunner. and ur good to go.OK kinda confused just a lil on which .xsvf to use with the trinity board A,B,C,or D cause it only talks about falcon jasper zyn an opus....??? just wondering
This is only for phat consoles that have been updated to 14717 or 14719 and cpu key has not been gotten before. You use rgh1.0 for slim trinity not this. J runner is ur friend.OK kinda confused just a lil on which .xsvf to use with the trinity board A,B,C,or D cause it only talks about falcon jasper zyn an opus....??? just wondering
Yes an thank youthis is only for phat since u have a trinity just use jrunner. and ur good to go.
yes it is love the program an figuared it out but thank you for the helpThis is only for phat consoles that have been updated to 14717 or 14719 and cpu key has not been gotten before. You use rgh1.0 for slim trinity not this. J runner is ur friend.
It hasn't been updated yet! Cmon read man.trying to glitch my Falcon with coolrunner to RGH 2.0. I have my nand-x hooked up but Jrunner says there is no RGH 2.0 yet?