GENERAL Team Xecuter Unlocked PCB

[sergiokazoom]

so i got the Team Xecuter PCB and i dont really know how to install it LoL ....sorta i Know you Replace it with the original PCB but how about the other small little part since there is soldered wires then would i have to strip the wires and put them inside of the other small part that comes with the Xecuter PCB? i have searched for a tutorial for installing the xecuter PCB i havent found one yet but if someone knows of one please direct me or if not let me know on how to do it as i have never done a Xecuter PCB Thank You Guysz!!!

 

[x360ccm]

this may give you a idea of how it to be fitted....

 

[diaboliq20]

ok - so drive with PCB furthest away from you......
wires attached to right hand side of PCB......
run these where the old wires used to go,a nd at the front of the drive (closest to you - you will see a prefect little spot for that extra board that came with it.......strip the original wires to reach this small board, and fasten them in following the colour guide.
plug the TX PCB wires into the socket and you're done after pluggin all the ribbon cables in.


EDIT - or after typing ALL OF THAT - just follow the fookin big picture above me LOLOL

 

[x360ccm]

ok - so drive with PCB furthest away from you......
wires attached to right hand side of PCB......
run these where the old wires used to go,a nd at the front of the drive (closest to you - you will see a prefect little spot for that extra board that came with it.......strip the original wires to reach this small board, and fasten them in following the colour guide.
plug the TX PCB wires into the socket and you're done after pluggin all the ribbon cables in.


EDIT - or after typing ALL OF THAT - just follow the fookin big picture above me LOLOL

prob best having step by step to lol.i was just to damm lazy to type it all tbh.:rolleyes2:

and dont forget the little black pad.aka heatsink fits onto the little grey/silver square bit on that ic.

the ic near the 5 wires.

 

[diaboliq20]

oh yeah......
OP - it's the one shown in grey on the IC chip near the 5 fly wires as dgenx says

 

[sergiokazoom]

ahhh ok Thank You Guyz simple enough oh and one more thing i dont have one of those wire strippers what is the best way to strip the wire cause i usually get a pair of scissors and they work but idk if i should do it for these kinda things haha

 

[diaboliq20]

yeah - be careful tho - scissors will do it lol

 

[x360ccm]

yeah dont cut yourself with them scissors..lmao.

also you got a small screw at the back of pcb you have to remove that,it's towards the right...

 

[sergiokazoom]

ahhh yeah hahaha i almost forgot the little ic heatsink LoL

---------- Post added at 09:29 ---------- Previous post was at 09:29 ----------

and thnx guyz

 

[[Death]]

lol i forgot heatsink too, yet mines been in my slim perfect for over a month lmao

 

[sergiokazoom]

Wow better put that on better to besafe than sorry.... And i learned the hard way LoL