the changes are not saved

[djj]

I'm sourry, my english isn't very good...

I'm from spain...

I have a Xecuter 3, when change the network configuration and restart
the xbox does not keep the changes. The configuration come back to default.

My bios is 2913

Thanks...

 

[nartac]

lots of people are posting this problem. My only suggestion is to use version 1959 for now until they release the fix.

 

[zBodger]

not sure if its just me but 1959 did not work for me at all - error18 (yes i know its related to incorrect files) - wierd thing is no erorr18 with 2913.

 

[djj]

With the bios 1959, when the power xbox the eject button blinks in red and green and the xbox does'n start

 

[nartac]

tell us exactly what version xbox, bios version you used, and control panel switch configuration you have set. I suspect you used wrong version of bios for your xbox or you have corrupted/bad bios.

 

[zBodger]

Im using an X3 in a V1.0 Bios 2913 flashed with on on off off off. Also flashed it to second bank using off on off off off with same results. I have a control panel attached.

Got the bin from xbox-hq and then again from xbins.
Any helps is appreciated - its not a huge problem since i can just reboot to dash and be fine but it would be nice to get it to go away.

Not sure if it helps but when i reflashed 1959 and restored the msdash i get an error5 (my drive isnt locked) when i boot with the chip disabled and no video no sound no frag when it is enabled.

 

[nartac]

zBodger, check your soldering on pins 13 & 14. Read this sticky: http://www.teamxecuter.com/forums/showthread.php?t=5764

 

[zBodger]

Thanks nartac ill check them - although ill have a fit if they are bad Nolga did the install

On second thought i think i may just live with the inconvinience and not f with the soldering.

 

[nartac]

if you paid for his service and you have problem, I would definitely contact him and see what he can do.

 

[pikapben]

I have been having this same issue. I listed a post here, but have not found any solutions.

http://www.teamxecuter.com/forums/showthread.php?t=25901

Nartac you say to check the soldering on pins 13 & 14 as indicated at this sticky.
http://www.teamxecuter.com/forums/showthread.php?t=5764
I have resoldered these pins several times. Is there anything particular to look for when resoldering here? You can find more details about my conditions on my post. Any advise would be great. Thanks!