there is an option to update the NAND via CoolRunner ?

[luminol]

Hello i'm think i'd a mistake on understand this progress.

first update my nand to V3 code through Ck3i , done this without problems.

solderd the 2 qsb of my nand-x set , dump my nand two times , compare , everything ok .

update my CoolRunner with XSVF of the falcon , everything ok .

after that ive began to solder the CoolRunner (easy insted the green wire , because he is too close to some resistor) , after that i've understand the i need to make ecc image , did it succesfuly without any problems, but now i've understand that i need to write this file to the NAND of my PHAT , that say that i need to desolder the 3.3V wire from the nand connection.
and solder again the qsb and write to the nand my IMG ECC?

there is an option to write the nand without the qsb just through the CoolRunner ?

Thank you ALL !

 

[Templeboy]

No you need nand x to write to the nand, you can connect the cable to where the qsb would go would do the same job, coolrunner cannot write to the nand

 

[luminol]

I've the NAND x , but I've disconnect my NAND QSb after finish the (that because a PDF tutorial of uber that said to install CR after dump) instead of generate ecc and write to NAND ) I'm gonna try do it with pin headers + hot air .

Hope ill do it good ...