These points are reading short on my Corona QSB V3 when using a multimeter

Status
Not open for further replies.

jdoe91011

VIP Member
Nov 18, 2013
156
0
Hi guys,

I just installed a Corona QSB V3 into my Corona and I have been unable to get a NAND read and JRunner is not recognizing my console. I went back and made sure all my solder points are good, and they all look good to me. I tested continuity on all of them using a multimeter, and they all test "open" on the mulitimeter with the exception of these two (see picturess) that test "short" on the multimeter. Is this normal? or is this indicative of something I can/need to fix?

Please let me know your thoughts

Thank you

QSBV3 Short Point 1.JPGQSBV3 Short Point2.JPG
 
Status
Not open for further replies.