http://www.teamxecuter.com/x3/tutorials/x3pin16.htm
i followed the steps on that page and i followed the picture in the sticky here for the pcb rebuild. i powered on the system and nothing happened. i removed the chip and the reset/eject adapter and the xbox booted fine. i put the chip back in, but not the reset/eject adapter and pressed the on button. the system came on, went off, came on, went off, then came on and started flashing green/red with no video. i turned off the system. removed the chip and it booted fine. i went back to check my steps and had skipped the step about soldering the 3 wire piece(hd led, lan led, d0 cable) i installed the d0 wire because i was lead to believe it was the only necessary one. the system wouldnt boot. i removed it and the chip and it booted fine. i installed all 3 wires and it wouldnt boot. i removed them and without the chip and reset/eject adapter the system comes on with red/green flashes and says 'needs service' with a 09 in the corner. is the xbox dead or is there still hope? and if there is hope please lead me in that direction. i searched forums and tried my hand in irc and now its 6am and im giving up for the night and posting this message. thanks.
what would help a lot would be a pic of the motherboard of a 1.6 with an x3 using the pcb rebuild. but any help is good enough.
the error code disappeared.
i followed the steps on that page and i followed the picture in the sticky here for the pcb rebuild. i powered on the system and nothing happened. i removed the chip and the reset/eject adapter and the xbox booted fine. i put the chip back in, but not the reset/eject adapter and pressed the on button. the system came on, went off, came on, went off, then came on and started flashing green/red with no video. i turned off the system. removed the chip and it booted fine. i went back to check my steps and had skipped the step about soldering the 3 wire piece(hd led, lan led, d0 cable) i installed the d0 wire because i was lead to believe it was the only necessary one. the system wouldnt boot. i removed it and the chip and it booted fine. i installed all 3 wires and it wouldnt boot. i removed them and without the chip and reset/eject adapter the system comes on with red/green flashes and says 'needs service' with a 09 in the corner. is the xbox dead or is there still hope? and if there is hope please lead me in that direction. i searched forums and tried my hand in irc and now its 6am and im giving up for the night and posting this message. thanks.
what would help a lot would be a pic of the motherboard of a 1.6 with an x3 using the pcb rebuild. but any help is good enough.
the error code disappeared.