tried updating nand without dumping

[usermalik]

i tried updating my nand without backing up the old one and i don't have my original nand, whenever i try to boot the console it just stops at the xbox 360 logo, tho i can boot into xell and get my get my cpu key. pls how do i resolve this?
thank you

 

[Xline]

if you don't have the original NAND then you have to use your CPU key to Rebuild you nand,,
from start.
Using the J-runner..

 

[usermalik]

how do i get the kv.bin?

 

[Taijigamer2]

Firstly dump the NAND that is on your console. U should have done this before U did anything else. Boot xell (with Xbox hooked up to router) then enter the ip given by xell into your chosen web browser. This will take u to xell FTP page where u can dump NAND, get keys, kv etc. then extract kv in jrunner as mentioned and rebuild NAND using jrunner ( guide in jrunner PDF) good luck.

 

[Big_Ddog]

i tried updating my nand without backing up the old one and i don't have my original nand, whenever i try to boot the console it just stops at the xbox 360 logo, tho i can boot into xell and get my get my cpu key. pls how do i resolve this?
thank you

If you used any of that online server crap and have a launch.ini that could be the reason why you are freezing on the logo.

You can do 2 things to test this:

1. Press eject shortly after the power button to clear your plugins.

2. If you have difficulty with the above. Put a clean launch.ini on a usb and boot your system. Usb will take priority over your hdd.

 

[usermalik]

was able to resolve it. booted to xell, dump nand, loaded nand in jrunner, input cpu key create xebuild. . . thanks

 

[Taijigamer2]

Well done, enjoy your homebrew.