A really challenging project that was pretty difficult for only been experienced soldering wires for car stereos. I literately screamed when I saw it booting to xell for the first time.
No rater tests, however the average boot time has been around 1 to 3 glitch cycles with an occasional 4-5 cycle boot cycle in some circumstances (restarting when the CPU is warmed up to 60-65 degrees c)
Dip switch settings = Only switch 3 on
Postbit jumpers = Default 0 ohms
Type of CPU_RST Cable Used (Default/Pro Cable/IPEX) = Default
Any QSB jumper/switch settings = No QSB
Any caps installed = None





No rater tests, however the average boot time has been around 1 to 3 glitch cycles with an occasional 4-5 cycle boot cycle in some circumstances (restarting when the CPU is warmed up to 60-65 degrees c)
Dip switch settings = Only switch 3 on
Postbit jumpers = Default 0 ohms
Type of CPU_RST Cable Used (Default/Pro Cable/IPEX) = Default
Any QSB jumper/switch settings = No QSB
Any caps installed = None





