RGH Trinity E71

[rendis.adio]

Hi,

I have Trinity with E71 error (1013). It was on 14719 Dashboard, Read NAND (no bad blocks), created ECC, wrote ECC, soldered CR with QSB. Xell boots fine but after writing Glitch Image it give me E71 error (Xell still boots fine). Tried also write Retail Image and desolder everything, still E71. I tried also disconnect HDD and everything, still the same.

I use J-Runner.

What should be the problem please? Thanks.

 

[gamehawk55]

Did you flash the original nand that you dumped back to the 360 or did you try to create a new retail image and flash that?

With your original NAND flashed back to the console try turning it on while keeping the sync button held the whole time and see if it will clear any corruption in the dashboard update.

Also did you read the nand twice and compare them to make sure they matched? Cuz if you only dumped it once and used that there may be a small chance that it wasnt read 100% corectly.

 

[rendis.adio]

I read NAND twice (J-Runner done it), they are the same. I created Retail Image in J-Runner (14719) and flash it via RawFlash v3. Should I try flash original dumped NAND?

I am at work now, i will try it next morning (with holding sync button).

 

[manwithoutname]

Try creating FreeBOOT with Multi Build and then flash via NAND-X.

 

[ball00]

You had o need to create a retail image to go back to stock. Flashing your original image back would get you back to stock 14719 dashboard

 

[x23are]

i had this problem on a jasper 16mb yesterday.
i fixed it whit create new freeboot and it solved.
but this error sometimes has another reason.
reason= default.xex on root of usb flash or external usb hdd

 

[rendis.adio]

1) I wrote original NAND, still E71.
2) Hold sync button and turned on console, it boots to Dashboard fine.
3) Did all steps of RGH installation and now it works perfectly.

Thanks everybody for your help.