I have started my 1st trinity 4gb rgh, once I read nand 2x and they match I create ecc and when I write ecc I get no errors but after unplugging for 10sec and try to boot via eject I get no green pulse from cr rev c. I have programmed trinity files in both prog and nor mode. I get a green and red when it is programming. When trying to boot xell with ecc written the fan seems to do this slight increase in revs every so often, not sure if it's as often as the console is trying to glitch. I have not tried anything with the jp or bridging anything on the actual cr. I'm on my mobile so not sure how to upload pics but will try to upload when I get home from work. Thanks, let me know if you need anymore info.
COOLRUNNER Trinity rgh not booting to xell
- Thread starter shillizzle
- Start date
nofeloniesyet
VIP Member
please fill out the template,but if cr isnt pulsing green,either somethings cold soldered,soldered wrong full stop,or you have damaged the cr.
Fill this out
http://teamxecuter.com/forums/showthread.php?t=96474
-Chris
Edit: nofeloniesyet u beat me to it.
http://teamxecuter.com/forums/showthread.php?t=96474
-Chris
Edit: nofeloniesyet u beat me to it.
Last edited:
Try resoldering your ground. I had this problem with a few trinities I was working on before and it would glitch sometimes, but most times the fan would just make weird noise or get louder.
stevety129
Full Member
Did you get the cpu key look at this video https://www.youtube.com/watch?v=lcDnOwKWxRQ&feature=c4-overview&list=UU86XwQgXnBys6ZQw4m9FhTg
Well, you cant make an omelette without cracking a few eggs. I burned the r3b15 pad and then trying to solder to the resistor my iron was too hot I believe, and lifted the resistor but nevertheless with no pros anywhere near me I have just taken this as a learning lesson that a wire install is out of my league. Mods can close this thread while I bury my head in the sand. Lol thanks to all who gave advice.