Hello, i am having a issue with my trinity. About 2 months ago i installed a coolrunner rev B and it was running perfect. Last week i ordered a Demon and installed it. I had some issues installing it but eventually got it going. When i was putting everything back together, the dvd drive, hdd, etc. I figure i accidentally caught the dvd drive on the stby_clk wire and pulled the pad. I did not realize this until i started doing fiddling and using some alternative points (i did remove the xclamp, but i put some screws in to re-apply the pressure). After i noticed that i pulled the pad i searched on how to repair it, then by accident i fcked the resistor so i took one from a spare board. So im pretty sure i did repair it for i do read 33ohms again. Can anyone help me pinpoint the cause of this? Oh and by the way it just beeps when i hit the power button, and if you listen closely you can hear something briefly, but im sure the noise is normal.
Pics: I only included the ones i thought necessary, if anyone wants more just ask.
pic1, the mess is just hot glue i had to remove and have not cleaned yet. And you can see where i fcked up.
pic2(btw i have disconnected the demon by removing the power cable and ribbon cabled) the big dap of glue is just holding the wires close together so it was simpler to solder
pic3(this is the reason why i think i did fix the stby_clk)
you might have to open images in new tab to see the full pic
Pics: I only included the ones i thought necessary, if anyone wants more just ask.
pic1, the mess is just hot glue i had to remove and have not cleaned yet. And you can see where i fcked up.
pic2(btw i have disconnected the demon by removing the power cable and ribbon cabled) the big dap of glue is just holding the wires close together so it was simpler to solder
pic3(this is the reason why i think i did fix the stby_clk)
you might have to open images in new tab to see the full pic
