Hi! I have a problem with coolrunner rev c and trinity. Readed 4 nand dumps, used Jrunner to create ECC, writed ECC, soldered coolrunner but it's not gliching when jumper set to "SLIM" so I tried to set to "PHAT" and after 1min and 10sec its go to XELL, so i get CPU and DVD keys. Again used Jrunner to create XeBuild and writed it, but when turning on after few minutes RED dot, error code 1101. When trying to turn on with EJECT button it goes to Xell. If jumper set to "SLIM" it not going to Xell (waited about 10 min). (R3B13 IT SHOULD BE SOME RESISTOR????????)
R3B13 IT SHOULD BE SOME RESISTOR????????
R3B13 IT SHOULD BE SOME RESISTOR????????
