Trinity with RROD but possible NAND fault !

E

evolvergt

Full Member
Mar 4, 2012
80
8
Guatemala
First, thanks for all the help I have gotten over my past posts, I want to thank all of you. I wanted to share my problem since I couldnt find a roadmap for this kind of problems, I think not everyone steps on this. Maybe someone can enlighten me :)

I have a Trinity I bougth that after a few seconds it shows the Red Dot, I installed the xecuter pins so I could read the nand with the JR Programmer v2, and this is what I got on J-Runner:

jrunner.jpgjrunner.jpg

The Red Dot shows after 3 seconds and I have the 1030 secondary code.

I want to know If its possible to fix the nand, I wanted to ask first before I install a cr rev c, I have a DGX that I havent flashed... Let me know what I can do, again thanks!
 
Last edited:
E

evolvergt

Full Member
Mar 4, 2012
80
8
Guatemala
The problem is that I bought this console "as is", It appears as if no one has attempted to read the nand or install a chip, I think it could be a dashboard half install issue... But anyway it may be remotely the cause...

By my J-Runner picture, do anyone see anything wrong? I can install a rgh and try to boot to xell?
 
nofeloniesyet

nofeloniesyet

VIP Member
Jan 16, 2011
4,830
128
Nowhere
evolvergt said:
I ran out of CR3 pros but I have one installed that I can swap with a rev C, I will post results when I do the swap. Thanks jsinger47 for the tip!
Click to expand...
if it is a nand fault,most i have seen is 0022 after botched update,glitch it,if itll boot to xell,extract kv,use fusesets to build a retail nand,bam. :)
 
You must log in or register to reply here.