Ok so let me just fill you in on the history.
I soldered everything in fine with the default install using wires and then dumped nand and wrote Xell and everything.
The console would not boot and the debug light would light so I moved the CPU_RST coiled wires around and change the size of the coil etc but as I was doing I kinda got pissed cus it wasn't working, got heavy hand with it and... ripped off the pad. :facepalm: So I repaired that by soldering a peice of wire to a point under the board going to a point on top of the board(you will see it in my pics). Then I soldered the CPU_RST coiled wire to the point i soldered the other wire to on the bottom of the board. No luck again tryed moving the coil etc.
I then desoldered all the wires accept the repair wire and booted the console with the default nand it worked perfect again.
So I soldered it all in again and try again nothing. I then removed most most of wires and replaced them with Kynar wire. I think this had a positive effect as the debug light now lights every few seconds but still wont boot.
I used the latest JTAG Tool to dump compare and flash.
I am absolutely lost right now for the past two days Ive tryed all sorts different wires different length alternate points the POST QSB everything but so far the current set up has been the best one.
You can find pics of the current set-up here: http://xbox360content.com/RGH
All the pics there are of this set-up so check them all.
Here is also I video of the console trying to boot:
http://www.youtube.com/watch?v=xviaptgUd4M&feature=youtu.be
---------- Post added at 09:23 ---------- Previous post was at 09:21 ----------
I cant find a edit button and noticed that I made a typo i wrote in the first paragraph that the debug would light I ment to write wouldn't. Sorry about that.
I soldered everything in fine with the default install using wires and then dumped nand and wrote Xell and everything.
The console would not boot and the debug light would light so I moved the CPU_RST coiled wires around and change the size of the coil etc but as I was doing I kinda got pissed cus it wasn't working, got heavy hand with it and... ripped off the pad. :facepalm: So I repaired that by soldering a peice of wire to a point under the board going to a point on top of the board(you will see it in my pics). Then I soldered the CPU_RST coiled wire to the point i soldered the other wire to on the bottom of the board. No luck again tryed moving the coil etc.
I then desoldered all the wires accept the repair wire and booted the console with the default nand it worked perfect again.
So I soldered it all in again and try again nothing. I then removed most most of wires and replaced them with Kynar wire. I think this had a positive effect as the debug light now lights every few seconds but still wont boot.
I used the latest JTAG Tool to dump compare and flash.
I am absolutely lost right now for the past two days Ive tryed all sorts different wires different length alternate points the POST QSB everything but so far the current set up has been the best one.
You can find pics of the current set-up here: http://xbox360content.com/RGH
All the pics there are of this set-up so check them all.
Here is also I video of the console trying to boot:
http://www.youtube.com/watch?v=xviaptgUd4M&feature=youtu.be
---------- Post added at 09:23 ---------- Previous post was at 09:21 ----------
I cant find a edit button and noticed that I made a typo i wrote in the first paragraph that the debug would light I ment to write wouldn't. Sorry about that.
