trouble installing 2.6CE on 1.6

S

skylinekiller

Junior Member
Jun 5, 2006
12
0
Install diagrams are spread out for this one. One over there for rebuild board, one over here just wire install, one there for Xaptr, etc..........

When I boot, xbox boots as if no chip is installed no matter what the three switches are set to. If I change the hard drive to an aftermarket, I get the flashing light telling me to call microsoft. The interior LED light is blue, all the other LED lights light up correctly on the slector switch. What is wrong? I don't trust that rebuild board, can I solder all the wires instead of using the board? If so where is the link?

If you are wondering about the BLUE wire, the pad on the rebuild board was torn and wasn't sure if it was good, so I connected the blue wire to complete it. Itried it with adn without the blue wire.

Thank you
 
S

skylinekiller

Junior Member
Jun 5, 2006
12
0
resoldered it

I checked the soldering and resoldered it. Now I get the christmas light when the chips is on, it doesn't even boot when the chip is on, Do I have to use the rebuild board? Where is the wiring diagrams for not using the rebuild board. I have never had so many problems with any chip PSX2 etc... DMS3/4. I blame the install directions from TEAMX. Very poor and too many different variations that are not complete.
 
S

skylinekiller

Junior Member
Jun 5, 2006
12
0
well I soldered the wires adn took out the rebuild board. Still getting the same error. Christmas light when chip is on. Solder points are good. I repeat, sodler points are good. The chip sux. Should not be sold for 1.6 or 1.6b. I'm going to go on a limb and say I have a bad chip, considering my experience. I should have researched it more. I see all the problems peopel are having and the lack of suport they get from TeamX. Horrible, horrible horrible, directions. It as if someone had 10 ideas and peiced them together on different pages.
 
T

thechomper

Junior Member
May 23, 2006
17
0
this chip is excellent,you must be doing something wrong,i used the solderless adapter for the v1.6,and had no problems,the support from these forums are excellent ,as i would not have been able to install with out the other members help.so stop talking sh*t,keep up the good work team x
 
U

upinsmoke

Full Member
Apr 18, 2004
50
0
www.XbMods.com
check your soldering nere RP7R2
Click to expand...
i have to agree it looks like you missed a solider point look were i up the arrow it has to be solidered on both sides

as far as the chip they run fine in 1.6's you just have to take your time and tripple check everything..
 
F

Fantmx

VIP Member
Feb 15, 2004
2,274
0
Check the switches with a multimeter. Also make sure they are completely plugged in.
 
You must log in or register to reply here.