I have a Trinity which RGH was made on in January. I wanted to remove RGH by flashing back original NAND but console displays red light after about 30s.
I tried programming with Rawflash v4, JRunner, MultiBuilder and resault is the same.
Before writting I read the nand and I noticed that there is a bad block at sector 0x0001A. But when I checked original nand there are no bad blocks. While I was writting with JRunner it didn't detect bad blocks (only when reading), but when writting with Rawflash it detected bad block. Is it possible bad blocks can happen later?
I tried remapping bad block by copying 1A block from original nand to 3FF position on original nand. Didn't work.
Any suggestions?
PS: Console is working with glitched image and CoolRunner.
I tried programming with Rawflash v4, JRunner, MultiBuilder and resault is the same.
Before writting I read the nand and I noticed that there is a bad block at sector 0x0001A. But when I checked original nand there are no bad blocks. While I was writting with JRunner it didn't detect bad blocks (only when reading), but when writting with Rawflash it detected bad block. Is it possible bad blocks can happen later?
I tried remapping bad block by copying 1A block from original nand to 3FF position on original nand. Didn't work.
Any suggestions?
PS: Console is working with glitched image and CoolRunner.
Last edited:
I ment back not bad.