We will see in this tutorial how to create a nand DevKit for a console equipped with RGH RGBuil V1.0.
hardware Requirements
- A PC
- Welding equipment
- An Xbox Glitchée with an internal HDD
- A USB module SPi
required Software
- NandPro 3.0.
- Drivers UsbSpi
- RGBuild V1.00
I: Preparation of files:
Step 1: Download RGLoader V1.0 system files and 14,699 (or 13,599).
Step 2: In the file system files 14699, you will find a folder filesystems and loaders, copy the contents of those records on file in the same directory name RGbuild V1.0
Step 3: Open the folder hdd filesystems, and copy the record 14,699-dev filesystems on a folder (vraichement created) on your hard disk 360 (eg via FTP).
Step 4: In the folder RBBuild, make a hard right click the file build.bat and change CPU SET-KEY with your CPU key
Step 5: Now copy it next to the build.bat file, your original nand fame NAND.bin
II: Creating the nand:
Step 1: Double click the build.bat file.
Step 2: Answer the two questions, in my case I use the file 14699 and that is a Slim console
Step 2: Press enter
You should see the end image created successfully
Step 3: Copy the file created in your folder nandpro.
III: Flash of the nand:
Step 1: Use Nand Flasher 360 By trancy
OR
Nandpro launch and use the following command
nandpro usb: @ w16-Image.14699 dev.bin
Be sure to observe the @ w16
Step 2: Start your console normally
end
hardware Requirements
- A PC
- Welding equipment
- An Xbox Glitchée with an internal HDD
- A USB module SPi
required Software
- NandPro 3.0.
- Drivers UsbSpi
- RGBuild V1.00
I: Preparation of files:
Step 1: Download RGLoader V1.0 system files and 14,699 (or 13,599).
Step 2: In the file system files 14699, you will find a folder filesystems and loaders, copy the contents of those records on file in the same directory name RGbuild V1.0
Step 3: Open the folder hdd filesystems, and copy the record 14,699-dev filesystems on a folder (vraichement created) on your hard disk 360 (eg via FTP).
Step 4: In the folder RBBuild, make a hard right click the file build.bat and change CPU SET-KEY with your CPU key
Step 5: Now copy it next to the build.bat file, your original nand fame NAND.bin
II: Creating the nand:
Step 1: Double click the build.bat file.
Step 2: Answer the two questions, in my case I use the file 14699 and that is a Slim console
Step 2: Press enter
You should see the end image created successfully
Step 3: Copy the file created in your folder nandpro.
III: Flash of the nand:
Step 1: Use Nand Flasher 360 By trancy
OR
Nandpro launch and use the following command
nandpro usb: @ w16-Image.14699 dev.bin
Be sure to observe the @ w16
Step 2: Start your console normally
end