RGH Two red light after connecting Drives

[laishramacha]

PPl heres my problem

1.My dasborad was 13599 when extract my nand.bin but after RGH i used 360 multibulder V7

to create my new Freeboot image using rawflash V4 via USB Drive and when i boot to my

dash it was update to 14699.Is this Normal?:crazy:

2.And when i boot to my dashbrd the console goes to 2 red light after 4-5 min & when i

reconnect my dvdv drive or HDD(250gb) Of pen drive it cant boot at all and give me 2 red
light blink :facepalm:

But when i boot to my Xellreload mode it stay normal,no red light at all
Sometimes when i insert my usb drive it pop u with E71 error
Here are the pic of my wiring

 

[Martin C]

1. If you built an RGH 14699 image, what else did you expect to appear?

2. You've disturbed the heatsinks when removing the board. You'll need to reapply thermal paste.

 

[WNYConsoles]

I believe his XBOX is going 2RROD (overheating) because it's bench tested with no fan connected?????

 

[Martin C]

A jasper shouldn't 2RL after a few mins with no fans, but it's a possibility.

 

[WNYConsoles]

A jasper shouldn't 2RL after a few mins with no fans, but it's a possibility.

I will agree with you on that, I have run them no fans for awhile but depending on ambient temperature, playing a game or not, and stock thermal tape disturbed I will bet that's the issue.

 

[laishramacha]

1. If you built an RGH 14699 image, what else did you expect to appear?

2. You've disturbed the heatsinks when removing the board. You'll need to reapply thermal paste.

does it mean it alryt

 

[Martin C]

Answering a question with a question helps nobody.

You built a 14699 RGH image and it boots to 14699. What else did you expect to happen?