LITEON DG-16D4S - SLIM Tx Pcb problem

B

bioflex

Full Member
Mar 2, 2010
45
0
i search the forums but could not find info specific to my problem so i decided to open this thread.

i have a tx pcb flashed with lt 2.0 but when i put it into my console the laser motor spins slowly instead of going fast so i am always getting open tray error, its the same with the original firmwire too. i tried the pcb on three different drives and its the same. Hope you guys can help me fix it, i dont think returning the pcb is an option becos i live too far away.

Thanks
 
B

bioflex

Full Member
Mar 2, 2010
45
0
its flashing perfectly, and yes the ribbon is tight all good, i have tried as much as 3 different drives. The motor just spins slowly
 
x360ccm

x360ccm

BANNED
Jan 18, 2011
3,616
0
south coast UK
well if you doing everything right.then it's a faulty pcb just send it back to your reseller.for testin and you get a replacement.

no point in messing around with it.
 
You must log in or register to reply here.