RGH TX please give us an answer to audobaud problem

[advapi]

Hello to everybody,
me and other people are getting mad on upgrading nand-x with ck3/i .. since I've not seen an official answer within this problem, can you please tell us what to do?

For revision D I've seen that there's a wire to solder...what for Ck3i?

I also start a pool to diagnose how many people have upgraded/not been able to... hope this helps you to determine how many people got problems...

 

[afiser]

no modification is necessary for the ck3i.

i followed the step-by-step on a windows 7 x64 machine and it worked perfectly.

 

[advapi]

that motherboard have you got? did u use a usb-hub? connected even the nand-x cable?

 

[afiser]

my computer motherboard is an ASUS P5E (X38 chipset), no usb hub was used. just used the front panel on my case, i plugged a usb into both the ck3i and the nand-x (not sure it needs to be plugged into the nand-x though).

 

[advapi]

I got a p55 chipset... brother of yours... have u set some compatibility mode in flash magic? run windows 7 with disabling driver enforcement?

 

[afiser]

I got a p55 chipset... brother of yours... have u set some compatibility mode in flash magic? run windows 7 with disabling driver enforcement?

oh yes, i booted with f8 and disabled driver enforcement, installed the ck3i driver because it was the first time i had hooked it up to the computer, opened cmd prompt with admin privileges. thats about as specific as i can remember

 

[advapi]

ok, even I installed drv in drive enfoce model, have u flashed with driver enforce model disabled?

 

[afiser]

ok, even I installed drv in drive enfoce model, have u flashed with driver enforce model disabled?

i believe i have as i'm fairly certain the nand-x drivers are signed (based on nandpro v2 but still work if you have updated your nand-x to v3)