Hi, after TX Replacement PCB mine liteon 0225 drive eject for about 1 cm. Here is video of behavior of drive [ame="http://www.youtube.com/watch?v=WFIXhM1RMtA"]http://www.youtube.com/watch?v=WFIXhM1RMtA[/ame]
I flashed drive with ck3i, x360usbpro and jf v0.1.92 Beta (304):
1. I set the switch to WP#=1
2. Intro the drive to put it in vendor mode
3. Click the 0x8c button (phat ticked) 0x8c -> 0x00
4. Write firmware
5. I set the switch to WP#=0
6. 0x00 -> 0x8c
7. Outro the drive 3 times -> 2 times key verification
Then I installed the original PCB and drive opens o.k.
So could be TX Replacement PCB somehow broken?
I flashed drive with ck3i, x360usbpro and jf v0.1.92 Beta (304):
1. I set the switch to WP#=1
2. Intro the drive to put it in vendor mode
3. Click the 0x8c button (phat ticked) 0x8c -> 0x00
4. Write firmware
5. I set the switch to WP#=0
6. 0x00 -> 0x8c
7. Outro the drive 3 times -> 2 times key verification
Then I installed the original PCB and drive opens o.k.
So could be TX Replacement PCB somehow broken?