LITEON DG-16D4S - SLIM TX Replacement PCB stuck on 0x8c

[karvaztor]

Good call.. as soon as I get my meter back I also bought a sputnik switch... just in case.. and it seems i'm gonna end up using it on the original pcb :/

 

[x360ccm]

keep trying to flick the switch,while trying to unlock it.

maybe a bit of dust got in it.

i no it's a long shot but worth a try.untill you get your meter back.

 

[karvaztor]

flicking the switch didn't do it...

---------- Post added at 17:23 ---------- Previous post was at 17:19 ----------

Older JungleFlasher (0.1.86 beta) fails too, but it actually tells me so instead of writing dots forever

"Sending Spi UnLock to Port 0x0000
UnLock Failed !
Spi Status: 0x8C"

 

[karvaztor]

There.. tested the PCB switch with a meter and the image bellow shows the result. Was that the expected result? Did I probe de correct points?

 

[karvaztor]

Hey... I've posted every picture and data I could... can anyone from the team offer me a final veredict? Is the board somehow broken? Should I go ahead and sputnik the original PCB then?

[ ]'s

 

[karvaztor]

Well... turns out it really was a defective TX PCB.. bought a new one and it worked as it should.. $100 thrown away (after shipping)...

 

[Ginjasy]

If it was defective can't you return to retailer for a refund?

 

[karvaztor]

Sure.. but I live in Brazil, the retailer is located on Canada.. It costed me $40 to have them send it to me.. It would cost me about the same to send it back... Gonna check with them, but I'm almost sure the whole thing, in the end, is gonna have costed me as much as a new xbox

Oh well...