Uh great looks like I've got a faulty Nand-X

[gargoyle67]

Getting ready to update my Nand-x prior to my coolrunner programing and it's not showing on any of my pc's in device managers, Not even the memoryaccess as per the software install tut :facepalm:
I've plugged it into 2x win7 machines and 1xXP pro, it doesn't even make the windows cuplunk sound when I plug it in. I don't supposed there's anything I can do apart from sending it back ? is it possible it shipped without any firmware on it ? I've also tried another micro usb lead, Same result, Red light lights up on the Nand-X btw.

 

[Ubergeek]

Have you tried flashing it ?

 

[jahoodi]

Mine did not make any sound or windows prompt when I connected it the first time, however it showed in device manager as "Memory Access" and I installed the drivers and worked just fine ..

Hope this helps.

 

[gargoyle67]

Have you tried flashing it ?

Thanks for your speedy reply Uber :smile:,
Haven't got the Nand-x update cable through yet, I was just going to install the drivers ready for the cable.
Would I be able to flash it even though it's not showing in device manager ?
@jahoodi, Thanks for your input buddy but as I said above I'm not even getting the memoryaccess icon in DM:frown:

I opened the Nand-X case to see if I could see any problems with solder points at the bottom of the board, I couldn't see any, But sometimes you can't with the naked eye.

 

[gargoyle67]

Got my cables & QSB today, Kept getting AutoBaud Errors when trying to program the Nand-X then I lowered the baud rate to 7200 and it programmed like a dream, Thought I may have one of the old update cables at first after a search, But thankfully that wasn't the case.
Strange my Nand-x shipped blank but I suppose these things happen :smile:
Time to program the coolrunners