GENERAL Unable to read demons nand

searchandfind

Junior Member
Aug 18, 2016
10
1
Hi,

So I recently conducted a wire install of a phat demon in to a trinity. I was able to get multiple good reads of the trinitys nand however I could not read the demons nand. In Jrunner it just read various variations of 'manufacturer for code FF not found'. I read that I should be able to read the demons nand without it even having to be installed in to the console so I de-soldered it and I am still getting the same errors.

I am using the Micro usb on the demon itsself and the switch is set to PC.

Thanks

Here is a photo of the board:

Code:
https://gyazo.com/9b8772baee22d00acb77b767f1dc68b4
 

rick48235

VIP Member
Sep 14, 2010
620
33
MICH
Hi,

So I recently conducted a wire install of a phat demon in to a trinity. I was able to get multiple good reads of the trinitys nand however I could not read the demons nand. In Jrunner it just read various variations of 'manufacturer for code FF not found'. I read that I should be able to read the demons nand without it even having to be installed in to the console so I de-soldered it and I am still getting the same errors.

I am using the Micro usb on the demon itsself and the switch is set to PC.

Thanks

Here is a photo of the board:

Code:
https://gyazo.com/9b8772baee22d00acb77b767f1dc68b4
upload all pic of your install
 

gavin_darkglide

VIP Member
Dec 14, 2012
2,311
118
Yes, you should be able to read/write to the demon nand. Infact the instructions that come with it, tell you to do that before you install, because the nand chips could be bad, and you dont get the warantee after it has been soldered to. You could try replacing the nand chip on the demon, but that is a tricky job, if you dont know how to solder well.