LITEON 0225 Unlocked PCB won't unlock.

F

freezebox

Junior Member
Apr 21, 2010
16
0
Hi,

Replaced my locked WINBOND 0225 with an unlocked TX PCB. It appears dead and I have tried everything mentioned in the thread to try and get it into vendor mode but it is not doing anything.

Any advise on how to flash it with a via 6421 or get it into vendor mode would be much appreciated as I am pulling my hair out.

i either get status 0x7F or 0x80
 
F

freezebox

Junior Member
Apr 21, 2010
16
0
i was hoping nobody would say that. There's no point in me paying £45 for the usb pro only to use it once ontop of the £40 i paid for this pcb. there must be a way to do it with sata like the 9504's were able to be done?
 
D

DUSTYB3N

VIP Member
Jun 17, 2011
462
0
Blackpool UK
Pay some body else to program the PCB. There are many members who I'm sure would be more than happy to do it.


Sent from my iPhone 4S using Keyboard
 
D

DUSTYB3N

VIP Member
Jun 17, 2011
462
0
Blackpool UK
Where abouts in UK are you?


Sent from my iPhone 4S using Keyboard
 
F

freezebox

Junior Member
Apr 21, 2010
16
0
dang :S If anyone from the uK could do that it would be much appreciated. I am trying to get it to work in jungleflaher but keep gettinng status 0x7f

:(
 
sarah1331

sarah1331

BANNED
Feb 22, 2012
867
0
Post us it mate I'll flash it I'll need your dump off you orig drive or send both unless its already been flashed once with correct fw just cover return postage

Or if you want to pop round giz a txt or call 2 Moro

Pm my number
 
Last edited:
A

alyshehata

VIP Member
Jan 26, 2011
377
0
i had the same problem and i could give u a hand on teamviewer tomorrow. i used my normal pc chipset and it was fine. PM me if u want
 
  • Like
Reactions: freezebox
You must log in or register to reply here.