i looked on the website and did not really find anything to help with this, i searched for a while. I went by the jungle flasher tutorials to read my old drive and then write that to the Unlocked Replacement PCB board all went great there and my log lookes just like the one in jungle flasher. I placed the board back in my drive the way it shoed to and once all was back to gather the drive will not stay closed when the xbox comes on. it just pops out as soon as the xbox comes on and will only close for a few sec once you hit the clos button any help would be great.
LITEON DG-16D4S - SLIM Unlocked Replacement PCB problems
- Thread starter alico18
- Start date
i reflashed the drive and made sure this time to send outro 3 to 4 times. Jungle flasher log lookes perfect when i read over it but once i put the xbox back to gather and cut it on the dvd drive pops out if you press the close on the xbox or on the controller it will close for a few secs and the pop right back out if you power off the xbox it will close and then once powered off eject out and stay out with the xbox off.
Martin C
VIP Member
Ubergeek
Xecuter Groupie
I used another Unlocked Replacement PCB i had and it worked great the first try so i believe that there is something wrong with either the piece that you put the wires in to or the wires them self. is there anything i need to know about UN-soldering the wires for the Unlocked Replacement PCB and soldering on wires straight from the drive it self? I have a 2nd slim that i need to put a Unlocked Replacement PCB in and i am just going to UN-solderer and re-solder the wires this time and see if that PCB board will work right.
---------- Post added at 13:51 ---------- Previous post was at 13:47 ----------
the peice that the wires went in to on the first pcb board looked different than the one with the 2nd one. The BRY had one green peice and the GW had its own on the 2nd on but on the first one BR had its own green piece and then YGW had is own if that makes any differences there.
---------- Post added at 13:51 ---------- Previous post was at 13:47 ----------
the peice that the wires went in to on the first pcb board looked different than the one with the 2nd one. The BRY had one green peice and the GW had its own on the 2nd on but on the first one BR had its own green piece and then YGW had is own if that makes any differences there.