RGH Update jasper RGH1 with official Update

[hazin_2000]

hello ,


I have jasper RGH1 and by mistake I update it with official update now it is not working.

advise please.

:crazy:

 

[BL4K3Y]

Are you 100% sure it's updated? Is it on dashboard version 16547 now?

I wrote a guide on how to apply the Avatar/Kinect update and it also explains the difference between a component update and a full system update.

 

[hazin_2000]

now only green light with black screen when try to read the nand after update no information's.

 

[gavin_darkglide]

Try writing back your stock nand dump and see if that boots. If the update blew the fuses, then RGH1 will no longer work, and you will need to change wiring to RGH2, or change to R-jtag.

 

[Slayertex6]

Rgh2/R-Jtag time if you didn't use any e-fuse protection, such as bridging the solder point or removing the resistor. Read up on e-fuse protection to avoid the same problem in the future.

 

[hazin_2000]

thanks for reply .

here what I have done.
1- wright back the orig nand 0022
2- build new orig nand with upgraded the LDV from 6 to 7 = 0022
3- build new rgh1 nand CR3 no green light
4-builed new rgh2 nand CR3 blinking green light no xell no boot
5-builed new rgh2 nand with only CPU key and new KV = blinking no xell no boot

:facepalm:

 

[Martin C]

TEMPLATE: RGH/JTAG help

Write the Jasper.ecc from j-runner/common/ecc to the console for RGH2.

 

[hazin_2000]

blinking green light no xell no boot

 

[koetjuh]

did you change the wiring from RGH1 to RGH2?

http://team-xecuter.com/forums/showthread.php?t=96474

 

[hazin_2000]

Sure

 

[Martin C]

I still don't see any images. If you cannot complete the template, we cannot help.