Something is off here. the demon reads and writes my nand, but now the xbox wont turn on with it on. It will turn on with it disabled though..... Any one have any thoughts..... it would turn on with it on before i updated it. Jrunner still recognises it as a demon, so it isnt the same problem the other person was having. this is really weird.
FIXED Updated demon to 1.04, and now xbox doesnt turn on with demon on
- Thread starter gavin_darkglide
- Start date
Pictures of the install? I just updated fw yesterday and mine still works.
Sent from my SCH-I605 using Xparent Skyblue Tapatalk 2
Sent from my SCH-I605 using Xparent Skyblue Tapatalk 2
i will try that, but it flashes my onboard nand fine, and the only camera i have is in my Girlfriends phone, and she is out with her kid at the moment..... and this was an alternate point install, which ended up burning off the a couple of nand pads, which i did trace repairs on, and now it reads and writes both nands fine, but wont boot with demon enabled...... i will order conversion board and see if that helps..... I installed the 10K ohm resistors, but the wattage may be off. and before i updated it it would turn on with demon enabled. it just wouldnt do anything.
Last edited:
i figured it out, J-runner doesnt convert a 256mb nand to 16mb nand unless you ask it to..... so created a stock 16MB nand image from 256MB dump, and it booted perfectly..... just have to fix coolrunner ribbon cable, it still attempts to glitch stock nand, but coolrunner glith light is really feint, and sometimes it boots, and sometimes i have to restart xbox. So thank you everyone for the advice, and team-xecuter for the awesome mods. keep them comming. 
Last edited: