RGH Updated FSD, now no boot?!

[installer_mss]

I searched and couldn't find a post about this particular issue so forgive me (and link it to me) if it has. I have a Jasper 256 that has RGH1 with coolrunner rev C. It worked fine since I glitched it about 3-4 years ago. I recently tried to update FSD via disc and it said it installed and to shut down then restart the console. I did but it would never boot again after that. It will go into XELL though. I no longer have the original nand dump as my HDD was stolen. When the console is powered up the coolrunner flashes green once then not again afterwards. Any help would be greatly appreciated.

 

[john mathews]

I searched and couldn't find a post about this particular issue so forgive me (and link it to me) if it has. I have a Jasper 256 that has RGH1 with coolrunner rev C. It worked fine since I glitched it about 3-4 years ago. I recently tried to update FSD via disc and it said it installed and to shut down then restart the console. I did but it would never boot again after that. It will go into XELL though. I no longer have the original nand dump as my HDD was stolen. When the console is powered up the coolrunner flashes green once then not again afterwards. Any help would be greatly appreciated.

u may have a curropted rgh image u have a hardware flasher such as nandx or jrp handy.u may have to build a new rgh image

 

[installer_mss]

I have both jrp and nand x. I tried reflashing but I get IOtimeout in jrunner. I reflashed the coolrunner but nothing changed. I no longer have the stock nand so I'm not sure how to build a new image from the one in the console. Can I use one from another console and manually type in the cpu key? It boots XELL so I still have the keys/fuses.

 

[GeekHeat]

Remove the hard drive, does it boot to dashboard ok if u do that.