updating nandx is it completely dead now?

[Jake69]

Hi I updated my nandx perfectly with my new ck3i, I unboxed my brothers nandx and plugged it in and it was erasing the blocks and got stuck on block 4, I get failed to autobaud untill I do the power on and off then I get failed to read device signiture do I want to proceed, then error says failed to communicate, and other times I get failed erasing block 1 have I messed this one up
thanks in advance

 

[Ubergeek]

Yep you killed it.

 

[Jake69]

Thanks for the reply I dont know if its a mirricle but iv somehow managed to revive it, I manualy erased all the blocks bit by bit and eventually got it to program, as you can see at the bottom of flash magic is the ammount of attempts iv made, it failed verifying and took many attempts to pick it up without it freezing erasing and writing. The nandx is displayed in device manager and I get 2 lights aswell when plugging it in before I only had the power light, have I erased anything I shouldnt by erasing all the blocks ( I thought I had nothing to loose by messing with it) and do you think its worth me retrying to erase and flash it iv spent nearly 3 hours on this was just about ready to chuck it out the window thanks again

 

[Jake69]

Hi just to let you know after putting the speed to 4800 I managed after about 6 attempts of writing because it was failing erasing blocks again and failing verifying then I managed to get it to erase and write and verify 100% it is being picked up in windows ok so its all good I hope

 

[Indestructable]

well done my friend

 

[mafia 5k]

i had the same messages, later to find out it was due to a incorrrect com port, although it still reads and writes fine , i was not able to update kept getting the error msg. something about my pc or the ck3 drivers, just let it be and bought a upgraded one for now