Hello
as most of you know i jtag consoles on a regular basis however today i have hit a problem. I Have two 2005 xenons one is november ( Launch Model ) One is october and i am using a nand x and before you say my soldering is bad its not, my soldering is okay however some of the points i had to solder onto the bottom of the points as the top points were rock solid and would not melt and yes i have used liquid flux and there is no reason why this should not work i have even solderd the yellow cable to another ground point on the board but still no flash controller, and yes i have the power in, rf board.
I Have two nand x's tried both and no luck one is faulty but tried just incase however i am still getting no flash controller i have used multiple cables the problem still remains.
And as the problem is with two of these i thought it might of been my soldering but ive resolderd and resolderd still the same issue.. im starting to cry. Any help?
My soldering is okay ive jtagged around 20 consoles in the past without a problem.
Thanks
as most of you know i jtag consoles on a regular basis however today i have hit a problem. I Have two 2005 xenons one is november ( Launch Model ) One is october and i am using a nand x and before you say my soldering is bad its not, my soldering is okay however some of the points i had to solder onto the bottom of the points as the top points were rock solid and would not melt and yes i have used liquid flux and there is no reason why this should not work i have even solderd the yellow cable to another ground point on the board but still no flash controller, and yes i have the power in, rf board.
I Have two nand x's tried both and no luck one is faulty but tried just incase however i am still getting no flash controller i have used multiple cables the problem still remains.
And as the problem is with two of these i thought it might of been my soldering but ive resolderd and resolderd still the same issue.. im starting to cry. Any help?
My soldering is okay ive jtagged around 20 consoles in the past without a problem.
Thanks
