This question may have been asked before and it can go in several different sub-forums so I will just ask it here hopefully it is a quick answer. So when doing R-JTAG, I install chip and load on cell-reloaded onto the nand. My question is instead of having to move back and forth between my upstairs and downstairs because I have to change the voltage when trying to get it to glitch, can I just plug it into j-runner and use pro rater with only the xell on there? I.e. will pro rater still detect a successful glitch with just xell on there or must I use the tv? Thanks.
BL4K3Y
VIP Member
You can use RATER if you like, but make sure the shutdown delay is set to at least 30 seconds.
This will give you enough time to grab the CPU key when XeLL boots.
This will give you enough time to grab the CPU key when XeLL boots.
chase
VIP Member
30 seconds may not be enough if you're grabbing CPU key from screen as it takes some time for the CPU key to scroll up and then you gotta write it down quick..
I always set mine to like 500 seconds.. then I can take my sweet time
I always set mine to like 500 seconds.. then I can take my sweet time
Last edited:
Martin C
VIP Member
xzanox
VIP Member
Wow you must write very slow, lol30 seconds may not be enough, gotta write it down quick..
I always set mine to like 500 seconds.. then I can take my sweet time
nofeloniesyet
VIP Member
how would I grab the CPU KEY when it is hooked up to my computer? I don't have it plugged into my tv or anything like I said the tv is downstairs. And as for Martin's response, would you happen to be able to provide a link to how to use POST monitor or just quickly give me the run down? Thanks.
chase
VIP Member
Oh yeah I see it so I can just use that instead of using cr3 pro rater they do the same thing. But how would I grab the CPU key without the xbox hooked up to a tv and without it connected to internet? Or is that not possible