Used Checkpoint 3.6.0 to backup saves, but when copied to new SD, Checkpoint doesn't recognize/show them?

[Mognar]

Hi all,

I just went through some issues upgrading to a new SD card. I finally have everything up and running and ran into one last issue I'm hoping to find some help with.

I used Checkpoint to create saves of the apps on my original card. Copied the nro and folder (with saves) to the new card. When I try to use Checkpoint to restore my saves, it doesn't show the saves I copied. It's only showing the saves that were in the OFW and subsequently copied to the new Emunand.

Any thoughts on how I can get these Checkpoint to recognize the copied saves?? I'm using Checkpoint 3.6.0.

If it matters, I installed each game fresh on the new card. Is that part of the problem? I tried going into a few games to see if they had to be launched once, but then Checkpoint sees the newly created data, but still not the copied saves.

Thanks for everyone's help!

Mog

 

[imprezgc8]

Are you restoring them to the same user?

When you backed them up did you launch Checkpoint with Full Ram?

 

[Alchemy.Gaming]

You have to create a new save by launching the game in order to restore the old one, but as long as your saves are in SD:Switch/Checkpoint/Saves, you should be able to restore each one. Make sure you are checking dates so you don't overwrite anything you don't want to.