I purchased a few Coolrunners early this year before I started college again. Didnt end up using them due to being in school and my focus being elsewhere.
I just picked up a Trinity from someone and was awaiting the DGX so I could get my key and RGH it.
I just got my DGX, Liteon PCB, and DemoN in the mail and am going to install it all here shortly.
I didn't buy a new CR since I already had a couple laying around.
They are Rev B's though.
I have been doing some searching/reading and from what I understand is that if I am going to use my Rev B CR with my Demon, I need to solder the "EN" point to the appropriate corner pin on the CR as there is not an official pad for it
Correct?
Also thought I read that I would need to update my CR via J-Runner using my DemoN?
Found the info on the sticky: http://team-xecuter.com/forums/showthread.php?t=88173
I am under the impression that I install the DemoN and CR like normal, solder to the pin on the CR to the add-on for the Demon... and then open up J-Runner to install the .xsvf to my CR?
Also under the impression that I will need to remove the C15 cap from my CR, but will not need the extra resistor where this is not a Phat install.
Also correct?
Sorry, but I just want to make sure I have it all down before I do the install. I spent a lot of money on all the stuff and don't want to screw it up. It's been a year since I've done any RGH's...
Thanks!
I just picked up a Trinity from someone and was awaiting the DGX so I could get my key and RGH it.
I just got my DGX, Liteon PCB, and DemoN in the mail and am going to install it all here shortly.
I didn't buy a new CR since I already had a couple laying around.
They are Rev B's though.
I have been doing some searching/reading and from what I understand is that if I am going to use my Rev B CR with my Demon, I need to solder the "EN" point to the appropriate corner pin on the CR as there is not an official pad for it
Correct?
Also thought I read that I would need to update my CR via J-Runner using my DemoN?
Found the info on the sticky: http://team-xecuter.com/forums/showthread.php?t=88173
I am under the impression that I install the DemoN and CR like normal, solder to the pin on the CR to the add-on for the Demon... and then open up J-Runner to install the .xsvf to my CR?
Also under the impression that I will need to remove the C15 cap from my CR, but will not need the extra resistor where this is not a Phat install.
Also correct?
Sorry, but I just want to make sure I have it all down before I do the install. I spent a lot of money on all the stuff and don't want to screw it up. It's been a year since I've done any RGH's...
Thanks!
