Yea, I had downloaded RGBuild 0v500 (for RGLoader 17150) and I was wondering if I could use it on my Falcon with RGH2+. I had tried to build the NAND on RGBuild twice, once with stock NAND, and the other time with 17150 RGH2+ NAND built with XeBuild. I had successfully built the dev/RGL NAND with the stock image, but when I flashed the image, the console would glitch forever. I tried to boot into Xell, didn't work either. So I re-flashed the RGH2+ 17150 image with my JRP 2.0 onto my console, which finally made it boot. I re-attempted to build my NAND, this time with the RGH2+ hacked image, which forcefully made RGBuild crash :facepalm:. Is there any way to run RGLoader on a RGH2+ console?
GENERAL Using RGLoader on Falcon with CR4 RGH2+
- Thread starter ZimHB123
- Start date
jligg
VIP Member
Id say its an smc issue. The cr4 requires its smc to glitch. When you build the image with jrunner and tick cr4 box jrunner uses it to build the nand image. When you build your image in rgbuild its not using that smc.
jligg
VIP Member
Having problems with RGLoader right now. It won't boot RGLoader at all and the boot animation never appears. Luckily, the console still boots Xell. Have the files in the correct place. I have rgloader.ini and bootanim.wmv on the HDD root and the 17150-dev folder inside of hdd:/Filesystems/ . Currently using my Jasper to look at the directories on XeXMenu. Any help would be appreciated. I might as well take this topic to the RGLoader forums too.