V. 1.00 and 2.6 lite CE problem

[Ragjin]

When i installed the chip everything was working fine. The flashbios screen came up. Then I flashed the wrong bios into it. So I ordered a programmer. Tried flashing x2_5035_vOld_512k into the chip in both banks but when I load it, it just frags. Am I doing something wrong?

 

[DJBOOBY]

if you got a v1.6 xbox flash it with X2 5035 v16 plus bios

 

[Ragjin]

I have a 1.0

 

[Ragjin]

I installed it in the pins way the first time. But took those out then installed it the wires way. When I installed it in the pins way, everything worked fine.
Flashbios would load up in bank 1 and bank 2. I flashed 1.6 into bios 1 then got fragged. Thinking it was a bad installation (i didnt know better) i installed it the wires way. Still didnt work. Flashbios still worked in bank 2. But bank 1 was messed up.
So i ordered a prgrammer then flashed x2_5035_vOld_512k into Bank 1 and 2 and the same for 3 and 4. Still nothing. So I flashed flashbios_v303 into bank 1 and 2 then flashed x2_5035_vOld_512k into 3 and 4 and still nothing. Still frags. I redid my D0 thinking it was that. Still nothing. What am I doing wrong.
My chip is a Xecuter 2.6 Lite CE and I have a 1.0 xbox. When I turn it on, it turns off, then on beeps, then turns off then back on then stays on and FRAGS with a blank screen.

 

[DJBOOBY]

just flash x2 5035 v16 plus to bank 1 if you have a v1.6 xbox then try chip

 

[Dreamreaper]

I have a 1.0

If you had a pin install then removed to do a wire install; I would be inclined on checking your solder points and the LFRAME.
Just thinking you did the install correctly the first time, you didn't by chance screw the wire install up did you?
You said you have a programmer, can you still detect the chip on the programmer?
Can you go back to a pin header install, you are obviously confident at soldering/desoldering because the V1.0 had the holes prefilled so you must have removed the solder initially to do a pin header install.