Hello everyone,
I've gotten a v1.3 motherboard that had a small conduction problem through one of the holes of the LPC. I resoldered that connection from the top to the bottom of the mobo and now it works fine.
Because I don't have a HD for it, I wanted to lock a HD onto that mobo and pulled my x3 from a v1.6. I used a wire install to put the x3 onto the v1.3. However, it constantly frags. It works on the original bios when I press a long time on the power button. I've checked all connections (continuity bottom-top of the mobo, connections to the chip), but don't see to find any problem. Is there a possibility that the motherboard doesn't work at all with a chip?
If I post the values of the voltage of each pin, would that help someone give me a better answer? thanks a lot guys! I hope this system will work by christmas
I've gotten a v1.3 motherboard that had a small conduction problem through one of the holes of the LPC. I resoldered that connection from the top to the bottom of the mobo and now it works fine.
Because I don't have a HD for it, I wanted to lock a HD onto that mobo and pulled my x3 from a v1.6. I used a wire install to put the x3 onto the v1.3. However, it constantly frags. It works on the original bios when I press a long time on the power button. I've checked all connections (continuity bottom-top of the mobo, connections to the chip), but don't see to find any problem. Is there a possibility that the motherboard doesn't work at all with a chip?
If I post the values of the voltage of each pin, would that help someone give me a better answer? thanks a lot guys! I hope this system will work by christmas