v1.3 X3CE does FRAG after flashing

[angus_jever]

I got a v1.3 and installed a X3CE with the pin header method. The lights on the X3 are blue blue and red, the switches are on on off off off, I flashed via disk the 1953 but after power on the xbox does FRAG. Making the same produre a second time, same disk, same switch position the system stops with "Unknown Flash! Halting" message but I think the flash is not protected. Doing the flashing again and again sometimes it flashed and than FRAG sometimes it stopped with the unknown flash message. So, what is my mistake? I used FlashBios 3.0.1, 1953, 2913.

 

[angus_jever]

Okay, I tried burning my CD with Nero and it works. I used an very old version of WinOnCD. If I had read the tutorial more carefully I used Nero in the first time. RTFM mistake I think.