I was installing an X3 into a verision 1.6 Xbox when during the
LPC rebuild I found that I had completely pulled the LAD1 connection right off the board (this was unfortunatly due to a clumbsy slip). I have tried to solder a connection onto this point again however it would appear that there is no metal in the hole to connect the wire to anymore.
What I wanted to know is if there is any other place on the board (either top or bottom) that the LAD1 connection surfaces again so I can run a wire to it to connect LPC pin number 10 to the new location that is the LAD1 connection (that I have killed).
Any help would be appreciated, as I very much doubt that I can repair this point.
I hope this all makes sense
LPC rebuild I found that I had completely pulled the LAD1 connection right off the board (this was unfortunatly due to a clumbsy slip). I have tried to solder a connection onto this point again however it would appear that there is no metal in the hole to connect the wire to anymore.
What I wanted to know is if there is any other place on the board (either top or bottom) that the LAD1 connection surfaces again so I can run a wire to it to connect LPC pin number 10 to the new location that is the LAD1 connection (that I have killed).
Any help would be appreciated, as I very much doubt that I can repair this point.
I hope this all makes sense
