CORONA v5 debug error

KILL3RCOOP3R

KILL3RCOOP3R

Full Member
Dec 3, 2013
68
0
Corona v5
Programmer Used: JRP v2.0
NAND Size:
Dashboard version: lastest
CB Version:
Screenshot of NAND details from J-Runner: (attach an image to your post)
J-Runner log
updflash.bin log (if applicable)
Was the console working before you started: Y
OK so the debug light doesn't come on unless I touch yellow wire. Then it either lights up or flash every so often. If I let it go then the light goes away. I have wrote ecc with cr4 box checked. I have tried the resistors I have used the different p1 settings I tried different dip settigs. Came getting the same thing. So starting to think it's my post adapter v2 the problem. But here are pictures
Sorry about that picture files was to big so had upload them to my drop box
https://www.dropbox.com/sh/nzik1muqlw97rkp/AAC0qH3maaaucu1Vt9fKIBsoa?dl=0
 
Last edited:
john mathews

john mathews

VIP Member
Jan 3, 2014
2,551
88
peoria illinois
KILL3RCOOP3R said:
Corona v5
Programmer Used: JRP v2.0
NAND Size:
Dashboard version: lastest
CB Version:
Screenshot of NAND details from J-Runner: (attach an image to your post)
J-Runner log
updflash.bin log (if applicable)
Was the console working before you started: Y
OK so the debug light doesn't come on unless I touch yellow wire. Then it either lights up or flash every so often. If I let it go then the light goes away. I have wrote ecc with cr4 box checked. I have tried the resistors I have used the different p1 settings I tried different dip settigs. Came getting the same thing. So starting to think it's my post adapter v2 the problem. But here are pictures
Click to expand...
where is the pics of install and jr log/ n if u touching the post out wire n its doing that u dont have a good connections pics please
 
You must log in or register to reply here.