Value of Post Pad when connected to GND?

[morinzo]

Martin C: Check each POST pad on the QSB against GND (with the console off and unplugged).

You should be getting values between 100 and 120k.

The above comment by Martin was made on a post about a Falcon.

I was wondering what the values should be on a Jasper? I'm getting between 67k-77k on this current install. It's booting the hacked Img, I just want to check it while I'm tuning it.

Thanks for reading and commenting!!

 

[Martin C]

Did you remove the POST ribbon and check this value?

 

[morinzo]

No Sir, I didn't see that comment in the post so I will do it now.

I'm getting the same readings with the ribbon cable disconnected & the power cable was disconnected too. Currently it's booting in 1-3 glitches.

 

[Martin C]

ok - it's a close enough figure.

All phats I've checked were all POST_OUT ranges of 100-120k.