Hey everyone.
I've come across a problem with my voltages. Right after they were all soldered, I measured the voltages a few times and every point was correct in correspondence with what Martin C posted in the Nand-X troubleshooting thread. So I tried to read the nand Using the Nand-X and JRunner but got "Can Not Continue" error. So I went back and checked the voltages once again to see that some of them had changed.
Points 2,5, & 6 all had the correct readings still, but 1,3, & 4 seem to be fluctuating with readings. 4 seems to switch between 0V and 3.3V every few checks which would make sense for a bridge between 2 and 4, but I checked for that with the multimeter. As for 1 and 3, they seem to be changing anywhere from .01V to .60V now. I checked for bridging on every one of them, which there was none. I also checked for continuity from the points on the top to their counterparts on the bottom of the board.
Thank you for your help.
I've come across a problem with my voltages. Right after they were all soldered, I measured the voltages a few times and every point was correct in correspondence with what Martin C posted in the Nand-X troubleshooting thread. So I tried to read the nand Using the Nand-X and JRunner but got "Can Not Continue" error. So I went back and checked the voltages once again to see that some of them had changed.
Points 2,5, & 6 all had the correct readings still, but 1,3, & 4 seem to be fluctuating with readings. 4 seems to switch between 0V and 3.3V every few checks which would make sense for a bridge between 2 and 4, but I checked for that with the multimeter. As for 1 and 3, they seem to be changing anywhere from .01V to .60V now. I checked for bridging on every one of them, which there was none. I also checked for continuity from the points on the top to their counterparts on the bottom of the board.
Thank you for your help.
