RGH Voltages on Blue, green and red wires

[DayvG]

Hey guys, I've just installed my second coolrunner, all seemed good, checked with multimeter etc. After I soldered the rear o the board I powered up and got the green light in the coolrunner. I then glued the wires in place and now only get the red light.

Just want to check what voltages I should be getting on the coolrunner from the aforementioned wires.

Cheers

 

[manwithoutname]

Try re-aligning your wires specially the green & blue ones.

 

[neophyte5001]

Make sure you programmed the coolrunner properly, but I'd bet that something happened between the time you tested and then glued. A weak joint will break loose easy, I'd go back and check your soldering.

I believe this is what's going on because I had the same issue with getting the PLL BYPASS (Green Wire) soldered on good, and I wasn't getting the green light at first. Went back, double-checked, resoldered, and all was well.

 

[DayvG]

I'm getting a voltage reading from the pll_bypass on the cool runner si i'm thinking its good.

---------- Post added at 22:44 ---------- Previous post was at 22:41 ----------

Try re-aligning your wires specially the green & blue ones.

Get the hell out of here!! Just separated them and VOILA!! Just gonna plug it in to the TV and check all is good!!

Update: All is good, Can't believe it was so simple!! I knew my soldering was good.....this time.